C O M P A C T   A T O M I Z E R   –   Z K - K O P F

Good things come in small packages

Often there is not a whole lot of space available inside machines, which can cause technicians a lot of headaches - especially if a lubricating system has to be retrofitted.
The compact design of this atomizer (18 x 30 x 15 mm - without fittings) makes it suitable for use in even the tightest spaces.

How it works:
The fluid hose is either laid into a pressure-free tank or connected. The atomizer should always be fixed a little above the maximum fluid level in the tank. With compressed air applied, the atomizer will instantly start to spray (a built-in check valve in the hose prevents the fluid level from dropping too fast). The atomizer can be actuated either permanently or on a cycle base by a control unit (e.g. BA) – but always in well-metered quantities.
The fluid is properly and economically fed into the centre of the air stream.
With the air and fluid choke (see picture) the amount of air and fluid is finely adjustable.



Technical data:

Material: Anodized aluminum, nickel-plated brass
Operating pressure: 3 - 8 bar (the higher the pressure, the finer the spraymist and the smaller the spray angle.)
Environm. temperature: -25 °C...+80 °C
Viscosity range: 1 - 200 mm2/sec. at 20 °C
Max. flow rate: 62 ml/min.
Max. cycle frequency: 60/min.
Spray angle: max. 30°
Max. air cons. at 6 bar: 54 l norm./min.
Noise level: 80 dB


Measuring examples for suction volume for 1 min. at 20 °C:
ISOVG150 2.1 ml at 5 bar compressed air
1.9 ml at 3 bar compressed air
Water 62 ml at 6 bar compressed air
48 ml at 5 bar compressed air
30 ml at 3 bar compressed air



Spray pattern – fluid H2O


Suitable accessories(please order separately):
Pneumatic hose: S-PU4
Fluid hose: S-PVC4
Fluid tank 1 liter: B01R/B01E







Order-No.
ZK-KOPF